I was thinking about this, and I wonder if it would be possible to leave the ball off and just have a hole for the bolt to pass through? Then people could add whichever size ball mount they want/need by getting a through hole ball. Even easier if, instead of using an M5 nut, it were to have a nut for 1/4"-20 since there are a plethora of balls with a 1/4"-20 bolt sticking out of them. Just something that might make it easier for people to adopt and you not be required to develop/build a separate mount for every size of ball that people might want.
I've looked into this multiple times and it never works. The cost difference between getting one produced with a hole and a ball on it is insubstantial. It's more offset when you factor in the additional hardware that will be needed to keep it in place. Pricing advances for purchasers would just not be there either.
RAM uses a 1" mount. That's what you're asking for, right? 20MM is for Offroam x Peak Designs.
Not here. The Scosche OBD II to USB Q3 adapter lit up red immediately after plugging it in.
Thanks. Sounds like I'll have to put in a ticket to have it checked.
Hey there, apologies for not seeing the post. You may want to look into a brim (preferred) or a raft (alternate) to get this to print correctly for you. You may also want to try something to promote bed adhesion to get it to stick.
There are install instructions on the website with a bit of info. Go SLOW though and don't force it. It's tricky the first time but it's easier once you get the hang of it.
