BCan
Well-Known Member
On my truck the driver side (both wheels) is about 1.5 inches lower. See attached pictures. The garage floor is level. If I park the truck in the same spot but just facing the opposite direction, the driver side sags the same way.
[/QUOTE
my guess would be, since they are both 1.5 low…it’s not an issue with one strut/sensor…it’s probably both. Have the service center take a look. I had the front pax sensor and strut replaced on the second SC visit…and that solved my issue. My front rgt was 1.5 low as yours…my rear was only .5ish…and that was just front rgt the truck leaning low and compressing the rear pax strut a bit. I had a tape measure in hand at the service center…I recommend you do the same. Good luck!On my truck the driver side (both wheels) is about 1.5 inches lower. See attached pictures. The garage floor is level. If I park the truck in the same spot but just facing the opposite direction, the driver side sags the same way.
Sponsored