Level out behind 3rd row?

[sbonder]

I see a lot of solutions for raised bed platforms, but haven’t found anything that just adds the couple of inches to the lower rear space. Anybody know of something? Or, some measurements for cutting a wood frame to do it? I prefer not to reinvent the wheel.
Thanks in advance.

Sponsored

 

[VSG]

Like this?
https://www.rivianforums.com/forum/...rs-for-flat-floor-my-3d-print-solution.23630/

 

[sbonder]

You are my hero.
Thanks!

 

[KBabione]

They're great and provide a nice level surface. I just put some velcro strips on the bottom of mine to keep them in place when I lift the subtrunk cover. The corner pieces didn't shift a lot, but I was getting tired of the center piece dropping into the subtrunk every time I removed the cover.

 

[sac602]

I used extrusion to make a more permenant solution. Dogs back there a lot so a. Flat serface is more useful. Had this installed 2 years now. https://www.rivianforums.com/forum/...-for-induction-burner-camp-kitchen-too.18935/

 

[bbonkk]

Slap a 2x2 at the tailgate side of the platform and use some Velcro to hold it in place and your done.

Sponsored