Originally, I watched Branden Flasch's YouTube channel and went with OpenSourceEV's Phone Ball Mount EVO and Spigen OneTap Pro MagSafe Wireless Charger, mounted between the two screens. One issue with it right there is there is no ventilation and the phone would overheat, especially in the...
I removed the panels before installation and kept them off for a few months while I went back and forth on WhatsApp with Hannshow. I ultimately got under the truck and measured several times and drew in pencil on the panels. Used my table saw to make the cuts and then reinstalled the panels.
My garage has been converted so I can only park in my driveway. My dryer outlet was not in use since I converted to a gas dryer 20 years ago. Since it was vacant, I ran an extension cord from my 30amp circuit to the front of the garage and mounted my portable charger. Now I'm upgrading to a...
I have a LE, vin 00004x (yes, under 50) and have been happy with it. One issue where a wiring harness came loose and rubbed against the wheel and triggered turtle mode. Other than that, Iāve been enjoying my truck since the end of May.
I had a ā07 Chevy Avalanche and was excited to hear about the Silverado EV. I put a deposit down in January. A series of medical issues ended with a quadruple bypass in late March. I didnāt want the work truck and the RST wasnāt going to be available until Summer ā24. I wasnāt willing to wait...
I noticed today that near the intersections of Lundy Ave & Commerce Dr in San Jose, CA there is a jet imbedded into the map. Anyone else see this or any other anomalies on the map?
Got my R1T LE,LG right before Memorial Day Weekend. I needed some running boards so my 5' 0" wife could get in and out of the truck a little easier (mobility issues after a few brain surgeries). I didn't care if they were rock sliders so I chose the most economical from EVBase using Branden...
LE, built 11/21, VIN 0000xx. I have the 12v in the frunk, under the dash, and gear tunnel. Didn't know about the 110v outlet below the climate control. Went out and took a look after reading this and there it was! In total, I have 3x 12v and 4x 110v outlets.
Has anyone run wire from the hitch to the 12v battery? I want to install an electric power chair and scooter lift/carrier on the hitch. Instructions say that I need to run the supplied wire to the battery. Has anyone installed one of these before? I would like to know the best/easiest route...