Search results

I had this SAME issue, until I took my R1T to an independent alignment shop. Gone are those issues I struggled with after two Rivian alignments and 16k miles and wrecked tires.

I had a similar issue on my R1T. A defective tire was the issue, Rivian replaced and was great after that. Apparently some of the Pirelli ‘shaved-spec’ tires are coming with flat spots, which feels like a tire balance issue when driving. Let us know how it goes when you get it back!

Oh good… I’m not the only crazy one… ;)

Reasons for my change; - cost (because not all of us have disposable incomes) :) Hence the use of some 2363 wheels vs getting something ‘nice’ or forged. - not having to recalibrate the vehicle as I change them myself - keeping most of my efficiency that I have on my 22s. I drive a fair...

Whelp, my R1T turned 1 year old (yesterday) … and cold weather is FINALLY in the forecast here in the PNW, so it was time to wrap up my 2363 project and get them installed. I chose Falken Rubitrek Tires (275/60R20 115T) to put on my 2363s. They are an AT tire similar to the Wildpeak A/T3W, but...

I HAD THIS SAME ISSUE, I no longer do. I took my R1T into the service center sometime around March (took delivery in Jan) of this year, before they got as busy as they are now. I had originally asked about the shaking, and to check the steering linkage/suspension hardware for proper torquing...

Same as many - Rivian charger on 60amp, always works, 25-27 mph. It lives outside on the exterior of the garage, just like my R1T.

Yeah… this was before they would have taken a clear coat… so they were unfinished…. But the 5 hours of meticulous masking and final prep were not to be… lol! Had the masking lines ended up razor sharp, I would have finished them… but my tires install next week and I need the paint to cure, so...

Well.. I tried, and I failed. They pass the 10' rule, but not the 3' rule when looking at them. Too many bleeds through the masking... but tried to make them look less... 'Ram-like' ... and now they look horrifically cheap.... lol! Flat black, here we come!

Finally getting around to priming after prepping them about six weeks ago, lol! Wheee!!!

THIS is VERY INTERSTING to me, and hadn't seen this mentioned before! My R1T tracks straight as an arrow (sans road crowns were applicable) ... however sometimes a phantom 'pull to the right' (driver aids turned off) will occur and last for a period of time, then go away. Because of this, I've...

Interesting you saw similar behavior when cold also. My vehicle/battery was also cold, ambient temp 39 degrees as mentioned before. Drive is slightly downhill from my house, drive is nearly exactly a mile to the RAN charger (yes, I'm proximity spoiled, lol) ... so not much acceleration or even...

Something I noticed this morning when picking up some juice from the Clackamas, OR RAN charger this morning… I swapped over to the gauge display right after starting a charge to see how quickly the motor temps would drop toward the ambient temp (39 degrees) … and the opposite was happening...

Well, if the rumor is correct, the name could be both 'Ascend' for off road ascents ... and 'Ass Send' with that kind of ridiculous 'lightspeed engage' power. ;)

Being a bit of a Halloween decoration geek, I’m quite excited about this update. I’m that neighbor with the 10k watt sound system and RGB laser and DMX lighting show and six fog machines… ? I missed Halloween mode by two months last year, so part of me is shaking with anticipation of adding my...

As others have said, is that 10+ per day? Then yes. ;) 13K miles so far, half shafts don't have 'tock' and everything is nice and tight. I also have no right to complain about the remaining rubber on my 22s. It all my fault... all my fault. Oh yes, 4-wheel powerslides are fun. This truck...

I don’t really have this issue either. We have a Model 3 and my R1T, and I find them both identically as responsive/occasionally sluggish at the same time, same behavior. Many of the PAAK issues actually stem down to your mobile device performance and settings, and not the car. If your FOB is...

Yup, that's the drain. As Dark-Fx stated, it's a one-way valve.

You could wash it out, there is a drain in the bottom… I had a slight odor in mine, and it came from the separator carpet. Gave it a wash, no more odor! it’s a pretty airtight space, so yeah, smells may linger, especially mildew-like smells and take out food. ;)

Well, you guys have inspired me. Thanks to all the collaboration and knowledge everybody has researched and shared on this thread. Last winter on 22” pirellis was, fun. Lol Got a full set in good shape for dirt cheap. Took a little while before a set popped up here in PDX, waited a bit and...