jimcaldwell
New Member
- Thread starter
- #1
I just picked up a R1T yesterday and have been following this forum for a long time. I’ve seen a ton of ideas for tonneau covers but I have not seen anyone try a bakflip revolver modified yet. Has anyone looked at one to see if you could cut it down to fit?
It seems like a good idea as you can just shorten width and length and just slide into the groves.
To take it out just pull and roll it up and put into the gear tunnel.
I found some used for $200 on Facebook
It seems like a good idea as you can just shorten width and length and just slide into the groves.
To take it out just pull and roll it up and put into the gear tunnel.
I found some used for $200 on Facebook
Sponsored
