Search results

Wow that's a great offer - I'm going to take you up on that. FYI - My ATV weighs about 700lbs.

Would this hold up to loading an ATV into the bed? or would the tires tear it up?

Would one be able to drive an ATV into the bed on top of the these mats? or would the tires rip them up?

just got an email, everything is back up

" One person in here fitted the Amazon's Soft tri fold tonneau using the home depot rails, so I wonder if the same rail can be used for the hard fold? " The rail for soft trifold you are referencing is for the 3 latches per side to catch on. The actual Tonneau sits on top of the bed. Very...

With no cover I'd suggest building an tall metal inverted L shaped bracket. Use 10mm bolts holding the plastic cover on to anchor the vertical portion of the L bracket, mount the antenna on the top of the L

The pics were taken with my test cable, and yes I put the grommet back in after slitting a hole in the center and passing the cable through

As mentioned above the grommets work for passing a wire into the cab. I used the right side upper grommet to pass a cable through. The cable came out at the top of the rear seat near the headrest. Using the rain channel on the floor of the bed I was able to tuck the wire up behind the panel ...

Does the 12V power inside the tunnel go to sleep or it always on?

Title says it all - curious if anyone has successfully passed a cable (power or coax) from the cab to the either the pickup bed or into the frunk. If so please share details.

thats because the soft trifold is out of stock so it defaulting to the more expensive hard trifold top

Thank you very much

Can someone please let me know the measurement/clearance from the bottom of the crossbars to the glass roof on a R1T?

Ok good - I just ordered your version and I bought some wing nuts and some small diameter plastic knobs to try first.

Krockett - does the channel bracket reach past the plastic liner lip to the harder surface? I ordered a more expense one (Tyger brand) and the bracket would not fit into the channel. The hook part of the bracket would only catch on the plastic liner lip which I knew would cause problems, so I...

Sounds almost exactly what I experienced

Mine also showed a move from 9 before I called, but I wasnt seeing the full amount expected. I went from 15mph to 18 mph and 10amps when I should have been at least 22mph and 11. After I called I'm seeing 11kwh and 22MPH consistently

Call Rivian an open a ticket. I originally had my Rivian charger on a 50AMP circuit used it a few times before upgrading to a 60AMP. I flipped the dip switch to reflect the highest level of charge 48 amps, but the charger never reflected that. Rivian logged in remotely and verified the issue...

What is the length of the bungy cords used?

I'm planning on doing this as well - What length Bungy cords?