New Rivian OEM drawer installed on Gen1

[dngo]

I cannot get mine to lock. I've done a reset too. Looks like i will have to submit a ticket.

I had a little trouble at first. Make sure you give it some force when inserting. Just sliding the drawer in gently didn’t get it to lock for me.

Sponsored

 

[Singletracker]

I have the BestEVMod drawer. It locks when driving and you must stop to unlock it via the main display. This is annoying, I agree. However, a piece of electrical tape over the contact at the back of the drawer defeats the lock, therefore the box remains unlocked at all times. It would be nice to have a quick way to lock it ONLY when one wants to do so.

Another thing to keep in mind - any box that sits in a separate tray is bound to have less usable space than one that doesn’t use a tray. These boxes are not very big as it is, so every little bit counts.

 

[AlohaR1T]

I had a little trouble at first. Make sure you give it some force when inserting. Just sliding the drawer in gently didn’t get it to lock for me.

I played around with it some more. I pushed into place, put in Drive, then put it back in park. It finally locked in place.

 

[Cogentfire]

I received my new OE drawer last night and installed it today on my Gen1 R1T. Despite what the website says, it indeed works with Gen1 and locks properly. The action is smooth and feels beefy. I was a little surprised that there’s so much of a gap between the front trim piece and the bottom of the opening but it doesn’t bother me. Just note that there’s the potential for things to come out under heavy braking.

I have the BestEVmod center console organizer and use it for my large metal water bottles, which don’t fit in the stock cupholders. It does limit the opening of the drawer but not enough to make it inconvenient.

Overall a nice accessory.

Disappointed the pattern on the rubber are not Rivian logos like the other trays in the truck.

 

[GA_Rivian]

I have no issues with the drawer I 3D printed. I have never looked at the screen to see if it recognizes it as a drawer, will need to check that.

Do you have design or stl files you're willing to share?

 

[Ready4Rivian]

Do you have design or stl files you're willing to share?

Here it is!

 

[GA_Rivian]

Here it is!

Thanks!

 

[RWerksman]

Thanks!

You may want to look at versions of this on Printables as well as this is going to be quite difficult to print successfully.

Here is the one that I did which prints with minimal supports and bolts together: https://www.printables.com/model/716472-rivian-r1t-and-r1s-center-console-camp-drawer-bolt

Here is a remix that is for smaller Prusa MK4: https://www.printables.com/model/800268-rivian-r1t-and-r1s-center-console-camp-drawer-bolt

 

[Ready4Rivian]

You may want to look at versions of this on Printables as well as this is going to be quite difficult to print successfully.

Here is the one that I did which prints with minimal supports and bolts together: https://www.printables.com/model/716472-rivian-r1t-and-r1s-center-console-camp-drawer-bolt

Here is a remix that is for smaller Prusa MK4: https://www.printables.com/model/800268-rivian-r1t-and-r1s-center-console-camp-drawer-bolt

Printed just fine on a Bambu X1 Carbon with no assembly

Sponsored