ArtXEng
New Member
- Thread starter
- #1
Hello!
I am working on designing a drawer insert and gear shuttle for the gear tunnel.
However, I don't have my R1T yet (fingers crossed I get it this spring).
I am looking for some accurate dimensions so that I can precisely design useful equipment that will fit.
I have contacted Rivian and can't get anything better than the rectangular dimensions and the cardboard cutout found on this forum is missing measurements that would allow for accurate mock up.
Would anyone have the ability to measure up the tunnel?
Better yet, anyone have 3D scanning capability to generate a model?
Cheers!
I am working on designing a drawer insert and gear shuttle for the gear tunnel.
However, I don't have my R1T yet (fingers crossed I get it this spring).
I am looking for some accurate dimensions so that I can precisely design useful equipment that will fit.
I have contacted Rivian and can't get anything better than the rectangular dimensions and the cardboard cutout found on this forum is missing measurements that would allow for accurate mock up.
Would anyone have the ability to measure up the tunnel?
Better yet, anyone have 3D scanning capability to generate a model?
Cheers!
Sponsored