Sponsored

repair

  1. Odd experience with Rivian Service - Seeking Advice

    Wondering if anyone has encountered anything similar and might haave any advice for trying to sort it out... Have encountered the seemingly well-known "clicking" noise in front wheel ends at low speed during acceleration and deceleration from/to a stop. From what I can gather, there are a...
  2. 2025 R1S - Minor fender bender while parked, 12v battery now causing inoperable

    Posting to share my experience and just check that everyone else is in this fever dream with me. About a month ago Someone barely backed into the front, passenger side fender of our Rivian R1S. Cosmetically, it's almost unnoticeable, however it appears it slightly bent the fender in towards the...
  3. Portland Area Rivian Repair Options?

    Looking for options for repair. I'm kind of convinced that this was a potential defective part, but can't prove it until a repair shop looks at it. The story.... Was installing brackets for EVSportline running boards on the passenger side of our R1S. I hand threaded the TP55 Torx bolt into the...
  4. How to fix A-pillar interior trim

    I recently got my R1S from repair ( the appointment for which in the first place took a long 4 months wait) for multiple issues one of them being- Dashboard wind noise. I don’t know what fix the SC did , wind noise insulation isnt any better now , but on the other hand, the driver side A...
  5. R1S Black Door Trim paint fix

    I noticed that my front driver and rear passenger doors where the meet at the top has paint missing. Don’t know how it happened but it’s noticeable. Anyone know of the specific kind of paint to touch this up with?
  6. Need Suggestions - Windshield Repair/Replacement

    Finally, I have a chip on my windshield, confirming my doubts about its quality. The chip is less than the size of a dime. What is the best solution: repair or replacement? I'm in the San Francisco - East Bay Area. Also please suggest options for Windshield protection. Feedback and...
  7. Dent - Need repair Advice / Guidance

    Unfortunate low speed, driveway ooopsie resulted in a sizeable dent in the rear quarter panel. Any advice or guidance on if PDR is possible or should I contact Rivian SC for the repair. I'm in the Raleigh, NC area, so any local repair knowledge would be immensely helpful. Thanks!
  8. Rally mode, gravel lot... Bad ending (tie rod)

    Well, showing off for my teenage sons and ended poorly needing a tow. Not sure how much this will cost me? Or how long need to wait for parts/service in AZ? Updated: Added the repaired photo and sharing link to VIDEO of the incident (truck is back all is good)
  9. 7 months later and a 50k repair bill, I have my R1T back!

    I was t-boned March 30 and finally got my truck back November 7th! Dealing with insurance, waiting on parts and repairs has been a slow nightmare. The bill was originally $9k to fix, then it went to $24k and finally settled around $50k. This last month it has been done and just sitting at the...
  10. Pyro fuse location?

    Hi I was wondering if anyone know the location of the pyro fuses in the Rivian and if they have any other circuit breaker for the HV battery I know one behind the cluster and found it any ideas if it has any other
  11. SLC Service Center Horrible - Unresponsive

    My vehicle has been with the SLC service center for 6 weeks. I called for an update today and they refused to speak with me. See attached text. My vehicle was damaged in a fender bender on April 8th. Minor damage, no airbags deployed. Rivian only certified one auto body shop in Utah, Dave's...
  12. Body work VT

    I took delivery on March 7th, and two weeks ago a contractor's trailer door got caught by the wind and put a small bit of scrape damage on my passenger-side rear quarter. Anybody in Vermont have a recommendation for a quality body shop?
  13. Brand new R1T, just drove over a screw—questions about tire servicing

    [Hi folks, apologize if this question has been asked before but I tried to find recent info and couldn't.] Yesterday I drove over a screw in my brand new R1T and immediately got a pressure notification. Went from 48 to 24 during the drive (did not have a choice but to slowly continue, as I was...





Top