Sponsored

Search results

  1. Mounting a cell phone. Has anyone done it?

    Those settings look fine for sure. Just make sure you have it oriented upright when printing. When printing, the ball end should be ant the top and the clip should be all the way at the bottom like how it would be oriented while mounting in the car.
  2. Mounting a cell phone. Has anyone done it?

    I would definitely recommend printing vertically using PETG. If you print it lying down, the layers will separate while installing since it is bending parallel to the layer lines. PET or another rigid flexible filament is needed so it can flex enough to install. PLA would definitely break and...
  3. Gear tunnel support leg

    I've been looking for this as well. I was hoping to find a support leg with the same 'step to extend' functionality since I'm designing my own kitchen system. Considering the other parts of the kitchen were mostly consumer available, it makes sense that the leg might not have been something...
  4. Mounting a cell phone. Has anyone done it?

    Here’s a new model I cooked up using the screen wedge technique. It holds pretty strong and puts the phone in a position that’s not blocked by the steering wheel. I included ball sizes for 15mm, 17mm and 1 inch. https://www.printables.com/model/327804-rivian-phone-mount


Top