Recent content by Mohelp

I used the thicker ( pink in believe) from the seats when they are up. Check where seats lift up by hinges , black tape is there with about 5 cables. The biggest one is a ACC on. Tap into it and that would solve your problem. Make sure to add a fuse to what ever you’re taking to your turn on. I...

Very easy. Towards back bottom( can’t miss them) has two screws (25 star I believe) once they are out, rest are pressure release as you pull.

If you’re removing the factory sub it’s easy to see + from -. For turn on signal I used I believe a pink and one, from that goes into the rear seat. It turns on and off with car. I can take a pick of cable and let you know.

Corret R1s has a single 10 in rear wall. I saw a lot of different ideas for the S. If I was you, best thing I saw was too. Take out 10 and put in an alpine type R shallow or even a JL10Tw3. Use same enclosure and just dyno mat area and stock enclosure (inside stock enclosure) Honestly I would...

Great. You can really feel the music. With 2 10s I’m not winning any stereo competitions but I sure as hell enjoying my music. Happy with the outcome.

Finally done and it works ?

The wife, two days after for everything. ?

Box is finally done. Will finish amp, wiring , etc in truck this week as time is available.

In my last car, I used a cigarette outlet's power cable in the trunk to power the LCQ only when the car was "on". Appreciate you sharing all these details. I'm getting inspired. It turns off and on by itself. All depends on how you set it up. It has auto on when it senses voltage in speaker...

I’m using this below. It has an auto on function with sensing voltage in the speaker cables. If for some reason it doesn’t work, I might have to tap off something. Hopefully I don’t have it cross that bridge. Audio Control LCQ1 Black Color 6-Channel Car Audio Line Output Converter with...

Day 2 progress Started off great and ended stressful. 4 gauge wire pull through to rear of truck was super easy 2/10 difficulty if that. I mounted a fuse holder using a few layers of 3m two sided car emblem tape. I decided not to attach cable to battery yet due to wanting to have everything...

Day 1 attempt progress Key note to all- in the middle in frunk there is these black rubber looking hoses. They are 100% for pass through. I pulled out a little and cut it shorter both inside and outside. I fished in my 4 gauge from the back of It (due only needing 2 feet max out) was easier to...

I did and I even called the shop. Problem was shop did it on the fly and had no info. Also I believe location was Arizona. If I still lived in Texas, or Florida, I would take it into a shop. I found a shop in Illinois, but the guy was on crack. He wanted around 2k just to build box. Just...