Recent content by Jason C

The WiFi in my gen 2 R1T no longer works since update 2026.15.0. It would connect for 30 seconds then say unstable WiFi. However my router is showing it’s still connected with and excellent signal. It’s not just my network I also tried my neighbors too. Once I was able to download 2026.15.30...

I was in your same boat. The only insurance company that would work with me is State Farm. Give them a try.

That’s the exact sound my vehicle makes. Thank you for the video.

I believe I have the same issue on my Tri motor. Can you upload a video so I can hear the sound. I thought the sound was coming from behind the rear seats. It’s like a sharpe creaking sound It happens when I perform a sharp turn or any side to side movement.

That’s what I was hoping for too.

Just wanted to clarify, the new design can slide out both directions or is it one or the other?

Then I disassembled my gen 1 I found this plastic duct was causing a lot of the noise. They should have made it out of rubber. It was rattling against the screen deck. Unfortunately my hand is blocking it but I do remember seeing a mount point you could utilize. I could definitely 3d print a...

@SoCal Rob Curious where you in Joshua tree? Looks like the road leading to Geology Trail. I experienced the exact same issue with my Launch edition Gen 1 R1T a few years back. I literally thought the upper dash pad was going to separate from the dash. If I remember correctly, I even tried to...

I no longer have my vehicle to confirm. But I purchased a set back in November of 2024. I’m pretty sure it stated max psi was 51 on the SL set I owned. I noticed a huge difference in ride quality between 44psi and 48psi (both measured at cold). This all makes sense now that the tires were...

I switched; it's been a world of difference for me. Definitely worth it.

After many different designs this is what I came up with. Here is my back story behind this project. I previously owned a gen 1 R1T. There has been countless post regarding the horrible OEM charger. I, like many others installed my own aftermarket charger. I was able to find the files on...

You will definitely want to print the compressor door lock in either PETG or ASA.

Awesome!! Glad it worked for you!

I didn’t have to remove the black plastic housing. Did you print it out of flexible material? I was able to fold it and slide it into place. I figured every vehicle will be slightly different or possibly off center so I designed the fingers on the outside for that reason. That way you can cut...

I just got back from the post office to figure out the most cost effective way to ship these. The total price with shipping would be $9.50. it’s breaks down to $3.30 for the print and $6.20 to ship it via USPS. Send me a message with your name and address and I will ship them out. For payment...