Recent content by dicion001

I'm still trying to think of a place to both store and charge a 12v jump device that's accessible from outside the vehicle with no power. It's quite a conundrum. You can get into the frunk with no power, but they removed the 12v from there :(.

Ya I'm sorry, your agent didn't know what they were talking about. Maybe as said above they mixed up 5G cellular and 5ghz Wi-Fi or something but I also have only a 5ghz network at my house (due to all my neighbors having tons of 2.4 clogging up the bands) and everything works fine on 5ghz.

Yea, already booked an appointment with Discount for tomorrow. They had half a dozen available in town. Sucks having to replace a tire with less than 6k on it lol.

Any and all shops will 100% say to replace it, because they absolutely won't come close to touching the liability of even hinting it's good to go. Even if it's 99% good to go, that 1% will make them tell you to replace it. Asking a shop these days, unfortunately, will not get you a fair answer...

Just noticed this yesterday. Rear passenger side. No idea how long it's been like this. I don't remember hitting anything or kissing any corners to cause this, but it was probably something like that. No issues holding air so far. 5000 Miles on the truck, have a full size spare. Should I swap...

Also, I discovered what the R105G represents. It's a Rivian specific electroplated coating: This company does it at least, Don't know if any others do https://webshop.facil.be/part/bf02152add/

Any idea if something like one of these would work? Maybe file down the edges a little bit more https://www.zoro.com/gearwrench-7-piece-38-drive-6-point-x-core-pinless-universal-impact-metric-extension-socket-set-84980/i/G0597958/

Tesla superchargers will slow charging based on the temperature of the NACS connector. If it gets hot, it slows down. That's why people were attempting to 'cheat the heat' by wrapping the handle & adapter in a wet towel or something to cool out down to prevent derating in the past. The easiest...

Makes sense why I've never seen it then. I'm in Texas where 50 degrees F is considered 'cold' lol.

I have never seen my motors get that hot ever. wth were you doing?

You are correct. Official procedure has the half shaft bolt removed, and the half shaft pushed back to create clearance to access the hub bolts. Once the hub bolts are tightened to spec (105Nm), then the half shaft is slid back in, and the half-shaft bolt REPLACED. it is not reusable. The half...

> (If anyone knows the torque spec, please share) 105Nm Last page https://www.rivianforums.com/forum/attachments/mc-11008362-0001-pdf.115725/ This also has the rivian approved tools and method to tighten them. Unfortunately it involves removing the halfshaft bolt and replacing it, as you...

So the above issue is an ongoing issue that is known about. Good news: People have looked after its been posted in the past and found one bolt completely missing and suffered no consequences, the truck still drove fine for who knows how long without it. Although not recommended, people have...

To actually answer your question, you'd need to pull them out, and charge/load test them individually. That's the only way to know. You could have batteries that are still 90% capable, or ones that are about to fail. No way to know without testing. I deal with a lot of lead acid UPS batteries...

Yup. 2024 here, no 12V in frunk. It's a not-well-designed situation, unfortunately.